Table of Contents
Advertisement
GS4000 Installation Guide Revision 4.00
(2) Attachment of a Power Supply
Comply with the following procedure when installing a Power Supply.
Step 1
Insert the power supply into the slot.
Power Supply
Figure 5.4-23 Power Supply Being Inserted Into the Slot
Step 2
Insert the power supply into the slot deeply until it reaches the end of the slot,
and fasten the screws of the power supply.
Screws
Figure 5.4-24 Power Supply Fixed Into Position
!
Step 3
Attach the power cable to the power supply.
(See section 4.5.4, which gives you the instruction related to the attachment or detachment of
the GS4000-80E2 power cable.)
WARNING: MAKE SURE THAT THE CIRCUIT BREAKER OF A POWER FACILITY IS SET TO
5-30
Caution: Use a driver when attaching a power supply, and make sure that it is fixed into
its position firmly.
OFF BEFORE ATTACHING OR REMOVING A DC POWER CABLE. ATTACHING
OR REMOVING A DC POWER CABLE WITH THE CIRCUIT BREAKER SET TO ON
WILL CAUSE AN ELECTRIC SHOCK.
Power Supply Slot
520-10-026-30X
Advertisement
Table of Contents
