Mitsubishi Electric MELSEC iQ-R Series User Manual page 206

■Applicable errors to the error detection setting
The following table lists errors for which whether or not to detect the errors can be set.
Error name
Power shutoff (either of the redundant power supply modules)
Failure (either of the redundant power supply modules)
Battery error
Module verification error
Fuse blown error
CPU module operation upon error detection setting
Set the CPU module operation upon error detection.
[CPU Parameter]  [RAS Setting]  [CPU Module Operation Setting at Error Detected]
Window
Displayed items
Item
Instruction I/O No./Network No.
Execution Error Specification Error
Device/Label/Buffer Memory
Specification Incorrect
File Name Specification
Incorrect
Operation Error
Memory Card Error
Module Verification Error
*1
Fuse Blown
Synchronous Interrupt Execution Interval Error
(CPU Module)
*1 Setting "Direct change setting" to "Enable" in "Online module change setting" causes a continuation error regardless of this setting. For
the online module change function setting, refer to the following.
 MELSEC iQ-R Online Module Change Manual
15 RAS FUNCTIONS
204
15.2 Self-Diagnostics Function
Description
Sets the CPU module operation when a specification error of I/O
numbers/Network numbers has been detected.
Sets the CPU module operation when a specification error of
Device/Label/Buffer memory has been detected.
Sets the CPU module operation upon a file name specification
error.
Sets the CPU module operation upon an operation error.
Sets the CPU module operation upon a memory card error.
*1
Sets the CPU module operation upon a module verification error.
Sets the CPU module operation upon a fuse blown error of
controlled module.
Sets the CPU module operation upon a detection of a
synchronization signal error on the CPU module.
Error code
1010H
1020H
1090H
2400H, 2401H
2420H
Setting range Default
• Stop Stop
• Continue