Item
Routing Setting
SFC Setting
Redundant System Settings
*1 When the device/label operation save setting is set to "Do not save", the value is 3504H.
Module parameters
The following are the lists of module parameters.
Ethernet function
For the module parameters relating to the Ethernet function, refer to the following.
MELSEC iQ-R Ethernet User's Manual (Application)
Memory card parameters
The following is the list of memory card parameters.
Item
Boot Setting
Setting of File/Data Use or Not in Memory Card
APPX
734
Appendix 8 Parameter List
Routing Setting
SFC Program Start Mode Setting
Start Condition Setting
Output Mode at Block Stop Setting
Redundant System Behavior Setting
Tracking Setting
Redundant System with Extension Base Unit
Signal Flow Memory Tracking Setting
Tracking Device/Label Setting
Extension Cable Redundant Error Detection
Setting at Startup
Automatic Standby System Recovery Function
Operation Setting at CPU Built-in Memory Boot
Boot File Setting
Data for Label Communication
Module Extended Parameter
Parameter No.
3800H
3C00H
3C00H
3C00H
5000H
5001H
5001H
5002H
5002H
Parameter No.
2000H
2010H