Event List - Mitsubishi Electric MELSEC iQ-R Series User Manual

37.2

Event List

The following table lists events related to the CPU module.
Event Event Event
code type category
00100 System Info
00110
00120
00130
00140
00400
00401
00410
00411
00420
00421
00430
00460
00700
Detected event Description
Link-up ■CPU module
The CPU module has entered into
the link-up state as a result of an
operation such as connecting a
network cable between the CPU
module and an external device.
■Redundant function module
The redundant function module has
entered into the communication
enable state.
*This event code does not indicate
the start of tracking communication.
Communication start/ Data communications with an
end (TCP) external device through TCP
connection started. Or, data
communications with an external
device through TCP connection
ended.
FTP connection start/ FTP connection with an external
end device started. Or, FTP connection
with an external device ended.
Receive frame error A receive frame error was detected.
SNTP server time Time setting by the time
synchronization synchronization function failed
failure because there was no response from
the SNTP server.
Power-on/reset The CPU module has been power-on
or reset.
Initial processing The CPU module has been powered
cancelled off or reset during initial processing.
Boot operation Boot operation was performed.
SD memory card SD memory card diagnostics have
diagnostics completed.
completed
Event history file An event history file was generated.
generation
Event history logging Event history logging from the
restricted module was restricted.
SFC program An SFC program could not be
continue start not resumed, and an initial start was
possible performed.
Label initialization After the data is rebuild (reassigned),
labels were initialized when the
system was powered off and on or
the operating status of the CPU
module was changed from STOP to
RUN. (Initial values were set or
values were cleared to zero.)
Tracking Tracking communication started.
communication start
Auto system A/B The system A/B setting was
setting automatically set by the redundant
system. (The setting was
overwritten.)
Detailed information
1 2
Operation Communication
source speed and
information communication
mode
Communication
status

Start-up
*2
information
Information on
the initial
processing
cancellation


Event history
file information
Module Restricted
information event
*3
category
 

System A/B
setting
information
37 EVENT LIST
37.2 Event List
3

37
633