Protective Covers, Doors, And Panels; Mechanical Safety - Siemens ADVIA LabCell Operating Instructions Manual

Centrifuge Module Interface Operating Instructions

Protective Covers, Doors, and Panels

The Centrifuge module covers, doors, and panels are designed to protect
you from potential injury from moving parts or exposure to potential
electrical or laser hazard.
WARNING
Do not remove any covers from the Centrifuge module during normal
operation without first contacting your local technical support provider,
unless instructed to do so in these operating instructions. Removing
covers may expose you to mechanical, electrical, biohazard, or laser
hazard that could cause bodily injury to you or could cause damage to the
automation system.
Note Close all access doors before operating the Centrifuge module.
Sensors on the access doors prevent the Centrifuge module from operating
if a door is open.
WARNING
Do not attempt to move or remove the Centrifuge module without first
contacting your local technical support provider. Moving or removing the
Centrifuge module without the supervision of a technical support
provider could result in injury and the loss of warranty coverage. If you
need to move or remove the Centrifuge module for any reason, contact
your local technical support provider.

Mechanical Safety

Several primary areas on an ADVIA LabCell or ADVIA WorkCell CDX system
contain potential mechanical hazards:
• Robots on the following instruments or modules:
○
○
○
○
• Pneumatic hose inside the Centrifuge module.
• Divert and interface gates, protected by the track covers.
• Main track and side tracks, protected by the track covers.
092D0001-02 Rev. A
Sample Manager
Centrifuge module
Dual ADVIA Hematology interface module
Stago STA-R interface module
Safety Information
page 85