Huawei DBS3900 Installation Manual page 365

DBS3900 (Ver.B)
Installation Guide
Prerequisite
Before soldering the connectors to the E1/T1 cable, ensure that both ends of the E1 cable are
disconnected from any devices. In addition, all the connectors are soldered to the E1 cable during
the same session.
Procedure
Step 1 Install an E1/T1 cable, as shown in
1.
2.
Step 2 In a position 20 cm away from the cable outlet module, strip the jacket for about 25 mm off the
E1/T1 cable to expose the shielding layer. Thread the E1/T1 cable through the ground clip to
ensure full contact between the shielding layer and the ground clip, and then tighten the M4
screws on the clip until the tightening torque reaches 1.2 N·m, as shown in
Issue 06 (2011-09-15)
WARNING
Link the DB26 connector at one end of the E1/T1 cable to the OUTSIDE port on the UELP
in the BBU, and then tighten the plastic screws on the connector until the tightening torque
reaches 0.25 N·m.
Lead the other end out of the cabinet through the cable outlet module on the bottom right
of the cabinet, and then connect the E1/T1 cable to the external transmission equipment.
For details about how to install the cable outlet module, see
Outlet Module in an OMB.
Figure 10-25 Installing an E1/T1 cable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Outdoor Scenario with AC Power Supply (BBU Installed
Figure 10-25.
in an OMB)
10.4.2 Installing a Cable
Figure 10-26.
352