Table of Contents
Advertisement
2 (From the preceding page)
No
Message display
Yes
Error display
- If HALT MEAS ON NG (halt operation on NG measurement) has been set to "YES" (page 9-2),
measurement will be interrupted at any point in the process if an NG measurement occurs the
same as when an error occurs.
PC calculation
No
Message display
Displaying the measurement result
(value, decision etc.)
No
Pattern display
Positional correction "yes"
Pattern display after correction
Determining the measuring time (timer stop)
Parallel output (Y0 to Y15), "BUSY" OFF
External interface enabled (communications)
No
Serial output
General purpose serial output
External interface enabled (key, parallel)
Waiting for a measurement start input signal or key input
7-13
Setting and Operating Outlines
1 (From the preceding page)
Yes
Yes
No
Yes
Pattern display during setting
Computer link
General purpose
Computer link output
7
Advertisement
Table of Contents
