Table of Contents
Advertisement
From the preceding page
Adjusting the camera position (after the camera is replaced or dislocated)
Adjusting the camera position/direction
Adjusting the lens aperture *
Rough
adjustment
Exists.
White area in the differential image
Adjusting the camera position/direction
Mismatch
Adjusting the camera position/direction *
Detailed
Mismatch
adjustment
(comparison of the centers of gravity)
Mismatch
Adjust these parameters using the following procedure.
Enter the through display mode
Adjust each parameter (adjust the camera and lens).
Enter the freeze display mode.
10. Store the image after replacing the camera by pressing the SET key in item 8 IMG
AFTR CAM CHNG on the [ADJ. CAM POSITION] menu.
[ADJ. CAM POSITION]
6DISP DEG OF MATCH (SET KEY)
8
7INTIAL CAM IMG
8IMG AFTR CAM CHNG (SET KEY)
10
9DISPLAY LABELS
9
0UPPER MENU
Start
None
Adjustment of size
(comparison of fillet diameters)
Match
Adjustment of position
Match
Adjusting the lens aperture *
Adjustment of brightness
(comparison of average light level)
Match
End
REG.
LABL10
LABL00 BER.CHG AFT.CHG
GRAVITY X 310.
GRAVITY Y 220.0
FILLET X
040
FILLET Y
040
AV-L.LVL
100
12-7
Other Settings and Operations
8. Press the SET key on item 6
DISP DEG OF MATCH
9. Compare the values before and
after the camera is replaced,
which are shown in item 9
DISPLAY LABELS
292.0
219.0
040
032
100.0
12
Advertisement
Table of Contents
