Table of Contents
Advertisement
[6] θ angle correction image display
Select "YES" or "NO" to display a θ angle corrected image on the [MAIN OPS MENU.]
On the [MAIN OPS MENU,] move the cursor to SET-SCRN item, and press the SET key.
- On the [SYSTEM SETUP] menu item, move the cursor to item 1,
OPS MENU SETTING and press the SET key.
[RUN MENU SETTINGS]
1MONITOR OUTPUT CAM1 CAM2 CAM1&2
2CAMERA1&2
3CAPTURE AN IMAGE PARTIAL-IMAGE WHOLE-IMAGE NO
4MESSAGE DISPLAY YES(RESULT.OK) YES(RESULT.NO) NO
5PATTERN DISPLAY MEAS-RESULT- OUT NO
6SHOW BINARY IMAGE YES NO
7
8DISPLAY + CURSOR NO YES
9OBJ.NO.MANL MODE NO YES
0IMAGE DISPLAY
qUPPER MENU
7SHOW
CORRECT IMG
YES
NO
[Operation procedure]
1. On the [RUN MENU SETTINGS] menu, move the cursor to item 7 SHOW CORRECT IMG, with
the up and down keys, and press the SET key.
2. Move the cursor to YES or NO with the left and right keys, and press the SET key.
[Display examples]
(Reference image)
· When the θ
angle correction
image display
mode has been
set to YES
· When the θ
angle correction
image display
mode has been
set to NO
See "Positional correction" (page 9·20) for details about θ angle correction.
CAM1=MD CAM2=MD
YES NO
MANL-MESR
FREEZE THROUGH
Description
A θ angle corrected image will be
displayed on the MAIN OPS MENU.
A θ angle corrected image will not be
displayed on the MAIN OPS MENU.
(Measured image)
8-7
Run Menu Conditions and Settings
Position of
reference image
8
Advertisement
Table of Contents
