Connection, Installation, And Wiring Of Iv-S20 Main Housing; Connection - Sharp IV-S20 User Manual

Installation Conditions and Method

6-2 Connection, installation, and wiring of IV-S20 main housing

[1] Connection

Connect the cameras (up to 2 cameras), remote key pad, and monitor to the IV-S20 main housing.
Camera 2 connector (CAMERA2)
Camera 1 connector (CAMERA1)
Monitor connector (VIDEO)
6
4
Camera 1
4
Camera 2
1 Connect the camera cable connectors to the camera 1 (CAMERA1) and camera 2 (CAMERA2)
connectors on the IV-S20 main housing. => See page 6-19, 6-23, and 6-27.
Note: Only connect or disconnect the camera connectors while the power is OFF.
- Push the convex side of the connector into the concave side of the mating connector. When the
connector is all the way on, it clicks.
- To disconnect the connector, hold the plug of the connector, and pull it straight out.
- A camera connected to the camera 1 connector (CAMERA1) is treated as camera 1 by this
system, and a camera connected to the camera 2 connector (CAMERA2) is treated as camera
2.
Note: You must have a camera connected to the camera 1 connector.
- The camera cable length is 3m. If you need a longer cable, order extension camera cable IV-
S20EC2 (cable length 2m) or IV-S20EC4 (cable length 4m).
3
Monitor
1
Remote key pad
1
2
Extension camera cable IV-S20EC2/4
6-8
IV-S20 main
housing
(plan view)
Remote key pad
connector (REMOTE)
IV-S20 main
housing
(side view)
Camera connector of
IV-S20 main housing