Table of Contents
Advertisement
Distance and angle measurement
Continued from pages 9-60, 9-61 and 9-63: GRAY & EDGE, GRAV.
[AUX. CONDITIONS] (TYPE00-MEAS.1-DST&ANGL MEAS)
1AUX.NO.
2AUX.TYPE
3POINT NO.1 :
4POINT NO.2 :
5POINT NO.3 :
6UPPER MENU
3
- Items
and
- If either PERIMETR (center of circle) or C-GRAV (center of gravity) is selected in item
5
item
will be displayed.
Auxiliary conditions
1AUX.NO.
(auxiliary number)
2AUX. TYPE
(auxiliary type)
3POINT NO.1
4POINT NO.2
5POINT NO.3
6UPPER MENU
The auxiliary when MID-PNT
has been selected
Point 1 (X1, Y1)
Center point
9
The center point is the coordinate
half way between points 1 and 2.
The auxiliary when C-GRAV
has been selected
Point 1 (X1, Y1)
Center of Gravity
X1+X2+X3
3
The center of gravity between points 1 to
3 is calculated as the mean of the three
The auxiliary when INTRSCT-PT has been selected
Point 1
Aux.: 2-P line
Crosspoint of the two lines that were
specified in "AUX.TYPE: LEG."
Return to the [MEASURING COND] (measurement conditions) menu and select item 5 DISTANCE
COND (distance conditions) if the GRAY&EDGE is selected, and select item 3 DISTANCE
CONDITIONS (distance conditions) if the GRAV (center of gravity) mode is selected.
Continued on the following page
00(0~15)
NO MID-PNT PERIMETR C-GRAV LEG INTRSCT-PT
ST-PNT00
AUX.NO
ST-PNT00
AUX.NO
ST-PNT00
AUX.NO
4
will be displayed unless NO is selected in item
Set this to any number from 0 to 15.
Select from NO (none), MID-PNT (set 2 points), PERIMETR (set 3
points), C-GRAV (set 3 points), LEG (set 2 points), or INTRSCT-PT
(set 2 points).
If the starting point number (either the starting point number or the
label number) is entered for points 1 to 3 (points 1 and 2 when MID-
PNT, LEG, or INTRSCT-PT is selected ) then the type of auxiliary
that was selected in 2 will be displayed next to each point.
This will return you to the [MEASURING COND] menu.
Point 2 (X2, Y2)
X1+X2
Y1+Y2
,
2
2
Point 2 (X2, Y2)
Point 3 (X3, Y3)
Y1+Y2+Y3
,
3
Point 2
Aux.: 2-P line
2
.
Setting details
The auxiliary when PERIMETR
has been selected
Point 1
Center of the circle
The center of the circle is the central coordinate of three
points positioned on the circumference of the circle.
The auxiliary when LEG
has been selected
Point 1
Point 2
A straight line between points 1 and 2.
9-64
Those settings already
established for auxiliary
points may also be used as
measurement conditions.
, then
Point 2
Point 3
Advertisement
Table of Contents
