Dell S4810 Reference Manual page 764

•
•
The following describes the do show interfaces command shown in the
following example. This example shows output with "Hybrid" as the newly added
value for 802.1QTagged. The options for this field are:
•
•
•
The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid command.
Example
Dell(conf)#interface gi 7/0
Dell(conf-if-gi-7/0)#portmode hybrid
Dell(conf-if-gi-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged gi 7/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: GigabitEthernet 7/0
802.1QTagged: Hybrid
Vlan membership:
Vlan
Native
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged gi 7/0
Dell(conf-if-vl-20)#interface gi 7/0
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
show interfaces switchport
Commands
interfaces on the switch.
switchport
vlan-stack trunk
network.
764
untagged frames and classify them as VLAN 10 frames
VLAN 20 tagged frames
True — port is tagged
False — port is untagged
Hybrid — port accepts both tagged and untagged frames
NOTE: Remove all other configurations on the port before you can remove
the hybrid configuration from the port.
10, Vlan 20
VlanId: 10
— places the interface in a Layer 2 mode.
— specifies an interface as a trunk port to the Stackable VLAN
— displays the configuration of switchport (Layer 2)
Interfaces