Qos-Policy-Output Ets - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

DCB OUTPUT POLICY

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The ETS configuration associated with 802.1p priority traffic in a DCB output policy

is used in DCBX negotiation with ETS peers.

If you disable ETS in an output policy applied to an interface using the no ets

mode on command, any previously configured QoS settings at the interface or

global level take effect. If you configure QoS settings at the interface or global level

and in an output policy map (the service-policy output command), the QoS

configuration in the output policy takes precedence.

qos-policy-output ets

To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.

qos-policy-output policy-name ets

To remove the QoS output policy, use the no qos-policy-output ets

Data Center Bridging (DCB)

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

NOTE: Please note that Dell Networking does not recommended to use this

command as it has been deprecated in the current 9.4.(0.0) release. A warning

message appears when you try to run this command indicating that you have

to use the dcb-map commands in the future.

— creates a DCB output policy.

dcb-policy output

— applies the output policy.

Enter the policy name. The maximum is 32 characters.