Neighbor Description - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

When you apply a default route to a BGP peer or peer group using the neighbor

default-originate command, changes to the configured default route-map

are applied to the BGP peer or peer group only after a delay of 15 seconds. As a

result, you must wait for a period of 15 seconds before manually resetting BGP

using the clear ip bgp command.

In case of eBGP, the neighbor default-originate command does not

support extended-community as a non-transtive route-map attribute.

You cannot set this configuration for a peer that is associated with a peer group.

Similarly, you cannot associate a peer to a peer group if that peer is already

configured with these settings.

In order that settings corresponding to the neighbor default-originate

command take effect, you must execute the clear ip bgp command

immediately after you execute the neighbor default-originate command.

neighbor description

Assign a character string describing the neighbor or group of neighbors (peer group).

neighbor {ip-address | peer-group-name} description text

To delete a description, use the no neighbor {ip-address | peer-group-

name} description command.

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Enter the IP address of the neighbor in dotted decimal

Enter the name of the peer group.

Enter a continuous text string up to 80 characters.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Border Gateway Protocol