Dell S4810 Reference Manual page 257

Parameters
any
host mac-
address
mac-source-
address
mac-source-
address-mask
mac-
destination-
address
mac-
destination-
address-mask
ethertype
operator
count
byte
log
monitor
Defaults Not configured.
Command CONFIGURATION-MAC ACCESS LIST-EXTENDED
Modes
Access Control Lists (ACL)
Enter the keyword any to drop all packets.
Enter the keyword host and then enter a MAC address to
drop packets with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the "Flow-based
Monitoring" section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
257