Mac Access-List Standard - Dell S4810 Reference Manual

Related
permit
Commands
seq

mac access-list standard

To configure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter
MAC ACCESS LIST mode. Also refer to the Commands Common to all ACL Types section and the
Common MAC Access List Commands section.
S4810
Syntax
mac access-list standard mac-list-name
To delete a MAC access list, use the no mac access-list standard mac-
list-name command.
Parameters
mac-list-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
Information
252
— configures a MAC address filter to pass packets.
— configures a MAC address filter with a specified sequence number.
Enter a text string as the name of the standard MAC access
list (140 character maximum).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Access Control Lists (ACL)