Dell S4810 Reference Manual page 891

Usage The following describes the show ip interface command shown in the
Information
following example.
Lines
TenGigabitEthern
et 0/0...
Internet address...
IP MTU is...
Inbound access...
Proxy ARP...
Split horizon...
Poison Reverse...
ICMP redirects...
ICMP
unreachables...
Example
Dell#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Dell#
Usage The following describes the show ip interface brief command shown in the
Information
following example.
Fields
Interface
IP-Address
Ok?
Method
Status
IPv4 Routing
Description
Displays the interface's type, slot/port, and physical and line
protocol status.
States whether an IP address is assigned to the interface. If
an IP address is assigned, that address is displayed.
Displays IP MTU value.
Displays the name of the configured incoming access list. If
none is configured, the phrase "not set" is displayed.
States whether proxy ARP is enabled on the interface.
States whether split horizon for RIP is enabled on the
interface.
States whether poison for RIP is enabled on the interface.
States if ICMP redirects are sent.
States if ICMP unreachable messages are sent.
Description
Displays type of interface and the associated slot and port
number.
Displays the IP address for the interface, if configured.
Indicates if the hardware is functioning properly.
Displays "Manual" if the configuration is read from the saved
configuration.
States whether the interface is enabled (up) or disabled
(administratively down).
891