Arp Inspection-Trust - Dell S4810 Reference Manual

Defaults Disabled
Command INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Related

arp inspection-trust

Commands validated against the binding table.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
S4810
Syntax
arp inspection-trust
Defaults Disabled
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
622
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
— specifies a port as trusted so that ARP frames are not
INTERFACE
INTERFACE PORT-CHANNEL
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
Dynamic Host Configuration Protocol (DHCP)