Permit - Dell S4810 Reference Manual

Example
Dell(conf)#ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related
ip access-list standard
Commands
show config

permit

To pass IP packets meeting the filter criteria, configure a filter.
S4810
Syntax
permit {source mask | any | host ip-address} {destination mask
| any | host ip-address} [count [bytes]] [dscp value] [order]
[fragments]
To remove this filter, you have two choices:
•
•
Parameters
source
mask
any
host ip-address
destination
count
bytes
dscp
order
Access Control Lists (ACL)
— configures a standard IP access list.
— displays the current configuration.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Enter the IP address in dotted decimal format of the network
from which the packet was sent.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address or hostname.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword bytes to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
233