Version 7.8.1.0
Version 7.7.1.0
Example
Dell(conf-router_bgp)#show config
!
router bgp 100
network 1.1.11.1/32
network 1.1.12.1/32
network 1.1.13.1/32
neighbor 10.1.1.2 remote-as 200
neighbor 10.1.1.2 no shutdown
show ip bgp
View the current BGP IPv4 routing table for the system.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] [network [network-
mask] [longer-prefixes]]
Parameters
vrf vrf-name
ipv4 unicast
network
network-mask
longer-prefixes
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
448
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view ipv4–unicast route information
corresponding to that VRF.
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
(OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
(OPTIONAL) Enter the network mask (in slash prefix format)
of the BGP network address.
(OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Border Gateway Protocol