show stack-unit stack-ports pfc details
Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational
mode on each unit with the configured priorities, link delay, and number of pause packets sent and
received.
S4810
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-
number} pfc details
Parameters
stack-unit
port-number
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Example
Dell(conf)# show stack-unit all stack-ports all pfc details
(Summary)
stack unit 0 stack-port all
stack unit 1 stack-port all
532
no pfc mode on
pfc priority 6-7
Enter the stack unit.
Enter the port number.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Data Center Bridging (DCB)