Show Stack-Unit Stack-Ports Pfc Details - Dell S4810 Reference Manual

Version
8.3.12.0
Version
8.3.16.0
Usage
Information
Example
Dell(conf)# show qos dcb-input
(Summary)
dcb-input pfc-profile
dcb-input pfc-profile1

show stack-unit stack-ports pfc details

Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational
mode on each unit with the configured priorities, link delay, and number of pause packets sent and
received.
S4810
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-
number} pfc details
Parameters
stack-unit
port-number
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
536
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
pfc link-delay 32
pfc priority 0-1
no pfc mode on
pfc priority 6-7
Enter the stack unit.
Enter the port number.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)