Permit Icmp - Dell S4810 Reference Manual

permit icmp

To allow all or specific internet control message protocol (ICMP) messages, configure a filter.
S4810
Syntax
permit icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} [message-type]
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
Defaults Not configured.
Command ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
918
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no permit icmp {source address mask | any | host ipv6-
address} {destination address | any | host ipv6-address}
command.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series TeraScale. Added the monitor
option.
IPv6 Access Control Lists (IPv6 ACLs)