Dell S4810 Reference Manual page 908

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip route summary shown in the following
Information example.
Column Heading
Route Source
Active Routes
Non-active
Routes
ospf 100
Total 1388
active...
Example
Dell>show ip route summary
Route Source
connected
static
ospf 100
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related
show ip route
Commands
908
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Identifies how the route is configured in Dell Networking
OS.
Identifies the best route if a route is learned from two
protocol sources.
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes
down, the non-active route becomes the best route.
If routing protocols (OSPF, RIP) are configured and routes
are advertised, then information on those routes is
displayed.
Displays the number of active and non-active routes and
the memory usage of those routes. If there are no routes
configured in the Dell Networking OS, this line does not
appear.
Active Routes
17
3
1368
1388
— displays information about the routes found in the switch.
Non-active Routes
0
0
2
2
IPv4 Routing