Fcoe Priority-Bits - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
S4810
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap
Defaults 0x8
Command PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage This command is available at the global level only.
Information
Data Center Bridging (DCB)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the priority-bitmap range. The range is from 1 to FF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
563