Dell S4810 Reference Manual page 121

tos
df-bit
validate-reply
outgoing-
interface
pattern pattern
sweep-min-
size
sweep-max-
size
sweep-interval
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring
(IPv4 only) Enter the type of service required. The range is
from 0 to 255. The default is 0.
(IPv4 only) Enter Y or N for the "don't fragment" bit in IPv4
header.
• N: Do not set the "don't fragment" bit.
• Y: Do set "don't fragment" bit
Default is No.
(IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
(IPv6 link-local address) Enter the outgoing interface for ping
packets to a destination link-local address.
(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.
Default: 0xABCD.
Enter the minimum size of datagram in sweep range. The
range is from 52 to 15359 bytes.
Enter the maximum size of datagram in sweep range. The
range is from 53 to 15359 bytes.
Enter the incremental value for sweep size. The range is from
1 to 15308 seconds.
(IPv4 only) Enter the outgoing interface for multicast packets.
Enter the IP address in A.B.C.D format.
• For a Port Channel, enter the keyword port-channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
121