set-pgid
Configure the priority-group identifier.
S4810
Syntax
set-pgid value
To remove the priority group, use the no set-pgid command.
Parameters
value
Defaults
none
Command
PRIORITY-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
Information
Related
•
Commands
•
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
S4810
Syntax
show interface port-type slot/port ets {summary | detail}
550
Enter the priority group identification. The range is from 0 to
7.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
priority-group qos-policy
priority-list
— configures the 802.1p priorities.
— creates an ETS priority group.
Data Center Bridging (DCB)