Show File-Systems - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.4
Version 8.3.11.1
Version 8.3.7.0
Version 7.5.1.0
E-Series
Example
Dell#show bootvar
PRIMARY IMAGE FILE =
SECONDARY IMAGE FILE =
DEFAULT IMAGE FILE =
LOCAL CONFIG FILE =
PRIMARY HOST CONFIG FILE =
SECONDARY HOST CONFIG FILE =
PRIMARY NETWORK CONFIG FILE =
SECONDARY NETWORK CONFIG FILE =
CURRENT IMAGE FILE =
CURRENT CONFIG FILE 1 =
CURRENT CONFIG FILE 2 =
CONFIG LOAD PREFERENCE =
BOOT INTERFACE GATEWAY IP ADDRESS =
Reload Mode =
Dell#

show file-systems

Display information about the file systems on the system.
S4810
Syntax
show file-systems
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
76
Introduced on the S4820T.
Output expanded to display current reload mode (normal or
Jumpstart).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Original command.
system://B
tftp://10.16.127.35/Dell-SI-9-0-2-0.bin
system://A
variable does not exist
variable does not exist
variable does not exist
variable does not exist
system://B
flash://startup-config
variable does not exist
local first
normal-reload
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
variable does not exist
10.16.132.254
File Management