Dell S4810 Reference Manual page 896

protocol
number [tcp |
udp]
src-port
number
destination-
port number
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.10.0
Version 8.5.1.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
This command provides egress port information for a given IP flow. This
Information
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information
when load-balance mac hashing is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table.
Example
Dell#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
896
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
Enter the keywords src-port then the source port number.
Enter the keywords destination-port then the destination
port number.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
IPv4 Routing