Management Route - Dell S4810 Reference Manual

Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-
port).
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0

management route

Configure a static route that points to the Management interface or a forwarding router.
S4810
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet}
To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
managementethernet} command.
Parameters
ip-address
mask
ipv6-address
prefix-length
forwarding-
router-address
IPv4 Routing
Introduced on the S6000.
Added support for IPv6.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
879