Version
8.3.12.0
Version 8.3.11.1
Usage
Dell Networking recommends configuring metrics on all interfaces. Without
Information
configuring this command, the IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
S4810
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults
Not enabled.
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
isis password
Configure an authentication password for an interface.
S4810
Syntax
isis password [hmac-md5] password [level-1 | level-2]
Intermediate System to Intermediate System (IS-IS)
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
995