Usage
You cannot delete a Management port.
Information
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
If your system has two RPMs installed, use the show redundancy command to
display which RPM is the Primary RPM.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
management route
Commands
interface or a forwarding router.
speed (Management interface)
interface null
Configure a Null interface on the switch.
S4810
Syntax
interface null number
Parameters
number
Defaults
Not configured; number = 0
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Interfaces
— configures a static route that points to the Management
— clears the FIB entries on a specified line card.
Enter zero (0) as the Null interface number.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
753