iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
S4810
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits
command.
Parameters
priority-bitmap
Defaults
0x10
Command
PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
This command is available at the global level only.
Information
show interface dcbx detail
Displays the DCBX configuration on an interface.
S4810
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type
slot/port
Command
EXEC Privilege
Modes
564
Enter the priority-bitmap range. The range is from 1 to FF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the port type.
Enter the slot/port number.
Data Center Bridging (DCB)