Configuring Dcb Maps And Its Attributes - Dell S4810 Reference Manual

E-ETS Configuration TLV enabled
R-ETS Recommendation TLV enabled
P-PFC Configuration TLV enabled
F-Application priority for FCOE enabled
I-Application priority for iSCSI enabled
-----------------------------------------------------------
Interface TenGigabitEthernet 0/49
Local DCBX Compatibility mode is CEE
Local DCBX Status
-----------------
Peer DCBX Status:
----------------

Configuring DCB Maps and its Attributes

This topic contains the following sections that describe how to configure a DCB map, apply the
configured DCB map to a port, configure PFC without a DCB map, and configure lossless queues. This
functionality is supported on the S4810 platform.
DCB Map: Configuration Procedure
A DCB map consists of PFC and ETS parameters. By default, PFC is not enabled on any 802.1p priority
and ETS allocates equal bandwidth to each priority. To configure user-defined PFC and ETS settings, you
must create a DCB map.
Data Center Bridging (DCB)
e-ETS Configuration TLV disabled
r-ETS Recommendation TLV disabled
p-PFC Configuration TLV disabled
f-Application Priority for FCOE disabled
i-Application Priority for iSCSI disabled
Remote Mac Address 00:00:00:00:00:11
Port Role is Auto-Upstream
DCBX Operational Status is Enabled
Is Configuration Source? TRUE
Local DCBX Configured mode is CEE
Peer Operating version is CEE
Local DCBX TLVs Transmitted: ErPfi
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
567