Trust Ipv6-Diffserv - Dell S4810 Reference Manual

Example
Dell#show ipv6 route summary
(Summary)
Route Source
connected
static
Total
Total 5 active route(s) using 952 bytes

trust ipv6-diffserv

Allows the dynamic classification of IPv6 DSCP.
S4810
Syntax
trust ipv6-diffserv
To remove the definition, use the no trust ipv6-diffserv command.
Defaults none
Command CONFIGURATION-POLICY-MAP-IN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.4.1.0
Usage
When you configure trust IPv6 diffserv, matched bytes/packets counters are not
Information
incremented in the show qos statistics command.
Trust diffserv (IPv4) can co-exist with trust ipv6-diffserv in an Input Policy Map.
Dynamic classification happens based on the mapping as shown:
IPv6 Service Class
Field
111XXXXX
110XXXXX
IPv6 Basics
Active Routes Non-active Routes
5 0
0 0
5 0
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series ExaScale.
Introduced on the E-Series TeraScale.
Queue ID
7
6
949