Debug Dcbx - Dell S4810 Reference Manual

Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Information
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

debug dcbx

Enable DCBX debugging.
S4810
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
562
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the type of debugging, where:
• all: enables all DCBX debugging operations.
• auto-detect-timer: enables traces for DCBX auto-
detect timers.
• config-exchng: enables traces for DCBX configuration
exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource
frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Data Center Bridging (DCB)