Neighbor Distribute-List - Dell S4810 Reference Manual

Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0

neighbor distribute-list

Distribute BGP information via an established prefix list.
S4810
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address |
peer-group-name} distribute-list prefix-list-name {in | out}
command.
Parameters
ip-address
peer-group-
name
prefix-list-
name
in
out
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Border Gateway Protocol
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group to apply the distribute list
filter to all routers in the peer group.
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to
allow all routes).
Enter the keyword in to distribute only inbound traffic.
Enter the keyword out to distribute only outbound traffic.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
423