Vrrp Mode - Dell S4810 Reference Manual

SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information,
refer to Spanning Tree Protocol
To enter SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree stp-id command. The prompt changes to include (conf-stp).
You can return to CONFIGURATION mode by using the exit command.
TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to
include (conf-trace-acl).
You can exit this mode by using the exit command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, refer
to Virtual Link Trunking
To enter VLT DOMAIN mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the vlt domaincommand then the VLT domain number. The prompt changes to include
(conf-vlt-domain).
You can return to CONFIGURATION mode by entering the exit command.

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more
information, refer to Virtual Router Redundancy Protocol
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include
(conf-if-interface-type-slot/port-vrid-vrrp-group-id).
u-Boot Mode
To enable u-Boot mode, press any key when the following line appears on the console during a system
boot: Hit any key to stop autoboot:. The prompt changes to include ( =>). For more information,
refer to S4810 u-Boot.
NOTE: You cannot use the Tab key to complete commands in u-Boot mode.
60
(STP).
(VLT).
(VRRP).
CLI Basics