Ip Igmp Version - Dell S4810 Reference Manual

implicitly assumes all sources are included. If you do not specify either include or
exclude, Dell Networking OS implicitly assumes a IGMPv2 static join.
Command Limitations
•
•
Related show ip igmp groups
Commands

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.
S4810
Syntax
ip igmp version {2 | 3}
Parameters
2
3
Defaults 2 (that is, IGMPv2)
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
726
Only one mode (include or exclude) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original
mode must be unconfigured.
If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration
for the group.
— displays IGMP group information.
Enter the number 2 to set the IGMP version number to
IGMPv2.
Enter the number 3 to set the IGMP version number to
IGMPv3.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet Group Management Protocol (IGMP)