Dell S4810 Reference Manual page 873

tag tag-value
vrf vrf-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version 9.2.
(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage Using the following example of a static route: ip route 33.33.33.0 /24
Information tengigabitethernet 0/0 172.31.5.43
•
•
•
IPv4 Routing
(OPTIONAL) Enter the keyword tag then a number to assign
to the route. The range is from 1 to 4294967295.
Enter the keyword vrf followed by the name of the VRF. Use
this VRF option after the next hop to specify which VRF the
next hop belongs to. This setting is used in route leaking
cases. Refer to Route Leaking.
Added support for VRF.
Introduced on the S6000.
Added support for tunnel interface type.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Added support for 4094 VLANs on the E-Series ExaScale (the
prior limit was 2094).
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
The software installs a next hop that is not on the directly connected subnet but
which recursively resolves to a next hop on the interface's configured subnet. In
the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
When the interface goes down, Dell Networking OS withdraws the route.
When the interface comes up, Dell Networking OS re-installs the route.
873