Session-Key - Dell S4810 Reference Manual

source-port
number
destination-
port number
Defaults none
Command CONFIG-CRYPTO-POLICY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
Usage
•
Information
•
•
•
Example
match 0 tcp a::1 /128 0 a::2 /128 23
match 1 tcp a::1 /128 23 a::2 /128 0
match 2 tcp a::1 /128 0 a::2 /128 21
match 3 tcp a::1 /128 21 a::2 /128 0
match 4 tcp 1.1.1.1 /32 0 1.1.1.2 /32 23
match 5 tcp 1.1.1.1 /32 23 1.1.1.2 /32 0
match 6 tcp 1.1.1.1 /32 0 1.1.1.2 /32 21
match 7 tcp 1.1.1.1 /32 21 1.1.1.2 /32 0

session-key

Specify the session keys used in the crypto policy entry.
S4810
Syntax
session-key {inbound | outbound} {ah spi hex-key-string | esp
spi encrypt hex-key-string auth hex-key-string
To delete the session key information from the crypto policy, use the no
session-key {inbound | outbound} {ah | esp} command.
Parameters
name
inbound
Internet Protocol Security (IPSec)
Enter the source port number.
Enter the destination port number.
Introduced on the Z9000, S4810, and S4820T.
IPv4 addresses support only -/32 mask types.
IPv6 addresses support only -/128 mask types.
Configure match for bi-directional traffic for optimal routing.
Only TCP is supported.
Enter the name for the transform set.
Specify the inbound session key for IPSec.
833