Show Config; Show Config (From Interface Range Mode) - Dell S4810 Reference Manual

show config

Display the interface configuration.
S4810
Syntax
show config
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Example
Dell(conf-if-fo-0/4)#show config
!
interface fortyGigE 0/4
no ip address
mtu 12000
switchport
no shutdown
Dell(conf-if-fo-0/4)#

show config (from INTERFACE RANGE mode)

Display the bulk configured interfaces (interface range).
S4810
Syntax
show config
Command CONFIGURATION INTERFACE (conf-if-range)
Modes
772
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Interfaces