Clear Ets Counters - Dell S4810 Reference Manual

Version
8.3.16.0
Usage
By default, equal bandwidth is assigned to each port queue and each dot1p priority
Information
in a priority group. To configure bandwidth amounts in associated dot1p queues,
use the bandwidth-percentage command. When specified bandwidth is
assigned to some port queues and not to others, the remaining bandwidth (100%
minus assigned bandwidth amount) is equally distributed to unassigned non-strict
priority queues in the priority group. The sum of the allocated bandwidth to all
queues in a priority group must be 100% of the bandwidth on the link.
ETS-assigned bandwidth allocation applies only to data queues, not to control
queues.
The configuration of bandwidth allocation and strict-queue scheduling is not
supported at the same time for a priority group. If you configure both, the
configured bandwidth allocation is ignored for priority-group traffic when you
apply the output policy on an interface.
By default, equal bandwidth is assigned to each priority group in the ETS output
policy applied to an egress port if you did not configure bandwidth allocation. The
sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority
groups must be 100%. Allocate at least 1% of the total bandwidth to each priority
group and queue. If bandwidth is assigned to some priority groups but not to
others, the remaining bandwidth (100% minus assigned bandwidth amount) is
equally distributed to nonstrict-priority groups which have no configured
scheduler.
Related
•
Commands
•

clear ets counters

Clear all ETS TLV counters on an interface.
S4810
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
538
Introduced on the MXL 10/40GbE Switch IO Module.
qos-policy-output ets — creates a QoS output policy.
scheduler — schedules priority traffic in port queues.
Enter the keywords port-type then the slot/port
information.
Data Center Bridging (DCB)