dscp
bit
operator
port port
destination
mask
count
byte
log
order
Access Control Lists (ACL)
Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
Enter a flag or combination of bits:
•
ack: acknowledgement field
•
fin: finish (no more data from the user)
•
psh: push function
•
rst: reset the connection
•
syn: synchronize sequence numbers
•
urg: urgent field
(OPTIONAL) Enter one of the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two
ports for the port command)
Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is
from 0 to 65535.
The following list includes some common TCP port
numbers:
•
23 = Telnet
•
20 and 21 = FTP
•
25 = SMTP
•
169 = SNMP
Enter the IP address of the network or host to which the
packets are sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL, E-Series only) Enter the keyword log to have
the information kept in an ACL log file. Supported on
Jumbo-enabled line cards only.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
227