Lldp Fcoe-Priority-Bits - Dell 8 Command Reference Manual

6

lldp fcoe-priority-bits

lldp fcoe-priority-bits
Sets the priorities on which FCoE traffic will be allowed.
Synopsis lldp fcoe-priority-bits value
no lldp fcoe-priority-bits
Operands value
Defaults The default value is 8.
Command Interface configuration mode
Modes
Description Use this command to set the priorities on which FCoE traffic will be allowed. The no lldp
fcoe-priority-bits command returns to the default setting.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the priorities on which FCoE traffic will be allowed:
See Also protocol lldp
108
Specifies the bitmap value. The range of valid values is 0 to 15.
switch(conf-if-te-0/1)#lldp fcoe-priority-bits 15
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01