Vlan Classifier Group - Dell 8 Command Reference Manual

vlan classifier group

Adds and deletes rules to a VLAN classifier group.
Synopsis vlan classifier group number [add rule number| delete rule number]
no vlan classifier group
Operands number
add rule number
delete rule number Specifies a rule is to be deleted. The range of valid values is 1-256.
Defaults There are no default configurations for this command.
Command Global configuration mode
Modes
Description Use this command to add and delete rules from VLAN classifier groups.
Usage There are no usage guidelines for this command.
Guidelines
Make sure your converged mode interface is not configured to classify untagged packets to the
same VLAN as the incoming VLAN-tagged packets. By configuring a converged interface to classify
untagged packets (by using classifiers or the default port vlan_id) to the same VLAN as
VLAN-tagged packets coming into the interface, the FCoE hardware sends out untagged packets to
the CNA. These packets may be dropped, disrupting communications.
Examples To add rule 1 to VLAN classifier group 1:
See Also none
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the VLAN group number for which rules are to be added or deleted.
The range of valid values is 1-16.
Specifies a rule is to be added. The range of valid values is 1-256.
switch(config)#vlan classifier group 1 add rule 1
vlan classifier group
3
57