Show Interface - Dell 8 Command Reference Manual

4

show interface

show interface
Synopsis show interface [port-channel number | {in | ex}tengigabitethernet slot/port | switchport |
tracked ]
Operands port-channel number
extengigabitethernet
intengigabitethernet
switchport
tracked
Defaults There are no default configurations for this command.
Command EXEC mode
Modes
Description Use this command to display the detailed interface configuration and capabilities of all interfaces
or for a specific interface.
Usage There are no usage guidelines for this command.
Guidelines
Examples To display detailed information for 10 Gbps Ethernet interface 0/1:
66
Specifies to display the port-channel number. The range of valid values is
1-63.
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
Specifies to display information for Layer 2 interfaces
Displays the tracked status of the interface.
switch#show interface intengigabitethernet 0/1
InTenGigabitEthernet 0/1 is admin down, line protocol is down (admin down)
Hardware is Ethernet, address is 0005.1e76.1aa5
Current address is 0005.1e76.1aa5
Pluggable media present, Media type is sfp
Wavelength is 850 nm
Interface index (ifindex) is 67174401
MTU 2500 bytes
LineSpeed: 10000 Mbit, Duplex: Full
Flowcontrol rx: on, tx: on
Last clearing of show interface counters: 00:02:18
Queueing strategy: fifo
Receive Statistics:
0 packets, 0 bytes
Unicasts: 0, Multicasts: 0, Broadcasts: 0
64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0
Over 1518-byte pkts(Jumbo): 0
Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01