Switchport - Dell 8 Command Reference Manual

switchport

Puts the interface to Layer 2 mode and sets the switching characteristics of the Layer 2 interface to
the defaults.
Synopsis switchport
no switchport
Operands none
Defaults By default, all Layer 2 interfaces are mapped to default VLAN 1 and the interface is set to access
mode.
Command Interface configuration mode
Modes
Description Use this command to set the switching characteristics of the Layer 2 interface. Use the no
switchport command to take the switch out of the Layer 2 mode.
Usage For changing the interface configuration mode to trunk or changing the default VLAN mapping, use
Guidelines additional switchport commands.
Examples To put an interface in Layer 2 mode:
To remove an interface from Layer 2 mode:
See Also show vlan brief, show interface switchport, switchport mode, switchport access, switchport trunk
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
switch(conf-if-te-0/1)#switchport
switch(conf-if-te-0/1)#no switchport
3
switchport
51