Dot1X Quiet-Period - Dell 8 Command Reference Manual

17

dot1x quiet-period

dot1x quiet-period
Sets the number of seconds that a switch remains quiet between a failed authentication and an
attempt to retry authentication.
Synopsis dot1x quiet-period interval seconds
no dot1x quiet-period
Operands interval seconds
Defaults The default time is 60 seconds.
Command Interface configuration mode
Modes
Description Use this command to set the time in seconds after which a switch attempts to perform
authentication after a failed authentication. Use the no dot1x quiet-period command to return to
the default setting. When a switch cannot authenticate a client, the switch remains idle for a
quiet-period interval of time, then attempts the operation again.
Usage Changing the quiet-period interval time to a number lower than the default can result in a faster
Guidelines response time.
Examples To change the interval time to 200 seconds:
See Also none
272
Specifies the time in seconds between attempts at authentication. The range
of valid values is 1-65535.
switch(config)#interface extengigabiethernet 0/16
switch(conf-if-te-0/16)#dot1x quiet-period 200
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01