Qos Commands; Cee - Dell 8 Command Reference Manual

QoS Commands

cee

Applies a CEE Provisioning map on an interface.
Synopsis cee default
no cee
Operands default
Defaults There is no CEE Provisioning applied on an interface.
Command Interface configuration mode
Modes
Description Use this command to apply the CEE map on an interface. Use the no cee command to remove the
CEE Provisioning map.
Usage The CEE map applied on an interface should exist on the switch.
Guidelines
Examples To apply the CEE map on an interface:
Because the switch does not allow applying a CEE map that does not exist, the following error
displays:
See Also cee-map
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Only a single map name, called default, is allowed.
switch(conf-if-te-0/1)#cee default
switch(conf-if-te-0/1)#cee test
% Error: Map does not exist
Chapter
16
239